Color Wash, Step 2 - An environmental emulsion for removing Color-Wash, Step 1. Small amounts of Color-Wash, Step 2 will remove Color-Wash, Step 1.
- Cut VOC emissions by 70% as compared to conventional two-step color change washes
- Extremely high ink solvency, yet gentle on rollers
- No hazardous ingredients per SARA III
- No chlorinates
Flash Point: 108°F (42°C)
VOC (lbs/gal): 6.85
VOC (g/l): 820
Cleaning Strength: Moderate
Drying Speed: Moderate
For best results, allow this product to reach room temperature before using. Cold solvents do not clean as well.
Apply a few ounces of Color-Wash, Step 1 across one of the distributor rollers and run in for at least 3 minutes.
Apply additional Step 1 to keep rollers wet. Lower the washup blades to remove Step 1. Apply Color-Wash, Step 2. If rollers slip, clean half the roller train first and then the other half.
HAZA: Applies to 1 Gallon
Product is hazardous only when transported by air.
HAZMAT surcharge applies.
Package size limitation of 1 U.S. Gallon applies.
Applies to ORM-D products as well.
NO-A: Applies to 5 Gallons
Product cannot be shipped by air due to volume limitation.
Product is not hazardous if shipped via ground.
No HAZMAT surcharge in ground transport.
MSDS on Varn Products shown on this page
Case price shown, is a discounted price.
- Models: VAR-CW2G & VAR-CW25