Meticulous construction guarantees position accuracy
Custom made to match your register system; stainless steel pins are mounted to a stainless strip ensuring accurate pin position on the light table or in the vacuum frame.
Most common pin sizes are available in any configuration, in pin heights of .070", .110", .145" and .200".
Pin Bar are a 1" with stainless steel base with buttons welded to them.
They are used either in the vacuum frame or on a light table.
The base thickness is .015, the sturdiest on the market.
Standard stock heights are .085" & .120". A height of .155 is also available.
Taller pin bars are available, but the taller the pin the more time it takes putting material on and off.
The common choice for inside the vacuum frames is .085", while the light table height is .120".
All pins are 1/4" diameter round, or 1/4" x 5/16" elongated, unless specified otherwise.
Custom height bars are available, but are not returnable.
Punch samples are required for quotations.
Directions for a punched template:
- Samples need only be a strip about 4" wide.
- Please do not fold the sample.
- Samples travel best curled into a square box rather than shipped flat.
- If you can only provide one sample, then we prefer a sturdy strip of mylar or film rather than a plate.
For orders of more than one bar please send extra samples
Call or e-mail for instructions on where to send the template.